Cold Vulcanized Rubber Pulley Lagging
التوفر: في المستودع
Trade with confidence on Abraa
طريقة دفعة آمنة وموثوقة باستخدام منصة عبرة للدفع عبر الانترنت
Supplier verification not completed
Pay only through Abraa to stay protected. Never pay a supplier by direct transfer.
Secure Payment
Pay through Abraa, never by direct transfer to a supplier.
Product Inspection
Book a check before shipping to confirm quality and quantity.
حماية المشتري
Get support and refunds if goods arrive not as described.
Verified Suppliers
Licence, address and on-site checks by the Abraa team.
مواصفات المنتج
مواصفات المنتج
| Specific Gravity | 1.25 Gm/cm3 |
| Standard Length | 10 Mtr, 33 Ft, 11 Yard |
| Standard Thickness | 6 mm to 40 mm |
| Standard Width | 1.2, 1.4, 1.5 Mtr, 48", 54", 60" inches |
| Country of Origin | Made in India |
| Is It Transparent | Non Transparent |
| Tensile Strength | Upto 20 MPa |
| You Supply In | Sheet, Roll |
| Thickness | 3mm - 30 mm |
| Brand | Rabbit |
Rubber lagging is manufactured using an abrasion-resistant top rubber layer and a buffed CN bonding layer to provide high levels of adhesion. Cold bonding is the process of gluing strips of rubber lagging straight onto the steel pulley. This technique has been used for many years due to its convenience and cost-efficiency. Cold bonding is less involved compared to hot vulcanizing and can be performed on-site when sudden lagging problems arise. If done properly, cold bonding can provide satisfactory results for light to medium pulley applications. However, cold bonding doesn’t offer 100% rubber tear adhesion which means service life is somewhat reduced.
\
منتجات مشابهة
View all
