24 Kv current and voltage sensor CVS-24-I

Alternative solution for metering and protection devices compatible with lo-po instrument transformers. typically recommended in installation conditions where the output cable is long or multisignal, or when the rated burden is too high. the active version is needed when the relay / meter cannot integrate the signal from the passive current sensor (rogowski coil).

very low voltage signals proportional to the primary voltage and / or current. features: high linearity, accuracy class up to 0,5 in the operating temperature range, analogue calibration in factory, compatible with output cables up to 100 m, no significant influence of the secondary burden. limits: auxiliary power supply needed, wide dinamic range but limited by the electronic circuit, rated frequency only.

Rated insulation level 24/50/125 kV
Rated primary voltage, Upn
* 20/√3 kV
Maximum voltage, Um 24 kV
Rated secondary voltage, Usn * 1 V
Rated voltage factor, Ku 1,9 for 8h
Nominal frequency 50 / 60 Hz
Nominal transformation ratio, Kn * 20/√3 kV / 1 V
Accuracy class *
3P for protection
0.5 for measurements
Accuracy on Harmonics Special Quality metering
Auxiliary Supply voltage ±12 Vdc
Max. Auxiliary Supply current 15 mA
Bandwidth (-3 dB) 100 kHz
Creepage 375 mm
Primary terminal capacity 1 pF
Weight 1,6 kg
Applicable Standards IEC 60044-7, IEC 60660