Indoor voltage sensor VS-24-I
Send a free RFQ and get the supplier's best price.
Trade with confidence on Abraa
Abraa güvenli ticaret sistemlerini kullanarak güvenli ve emniyetli ödemeler
Supplier verification not completed
Pay only through Abraa to stay protected. Never pay a supplier by direct transfer.
Secure Payment
Pay through Abraa, never by direct transfer to a supplier.
Product Inspection
Book a check before shipping to confirm quality and quantity.
Alıcı Koruması
Get support and refunds if goods arrive not as described.
Verified Suppliers
Licence, address and on-site checks by the Abraa team.
Ürün Özellikleri
| Altea Soltuions | |
| New | |
| YES |
Product Descriptions
Alternative solution for metering and protection devices compatible with lo-po instrument transformers. typically recommended in installation conditions where the output cable is long or multisignal, or when the rated burden is too high. the active version is needed when the relay / meter cannot integrate the signal from the passive current sensor (rogowski coil).
very low voltage signals proportional to the primary voltage and / or current. features: high linearity, accuracy class up to 0,5 in the operating temperature range, analogue calibration in factory, compatible with output cables up to 100 m, no significant influence of the secondary burden. limits: auxiliary power supply needed, wide dinamic range but limited by the electronic circuit, rated frequency only.
Datasheet:
|
Rated insulation level |
24/50/125 kV |
|
Rated primary voltage, Upn * |
20/43 kV |
|
Maximum voltage, UM |
24 kV |
|
Rated secondary voltage, Usn * |
1 V |
|
Rated voltage factor, Ku |
1,9 for 8h |
|
Nominal frequency |
50 / 60 Hz |
|
Nominal transformation ratio, Kn * |
20/43 kV / 1 V |
|
Accuracy class * |
3P for protection 0.5 for measurements |
|
Accuracy on Harmonics |
Special Quality metering |
|
Auxiliary Supply voltage |
±12 Vdc |
|
Max. Auxiliary Supply current |
15 mA |
|
Bandwidth (-3 dB) |
100 kHz |
|
Creepage |
375 mm |
|
Primary terminal capacity |
1 pF |
|
Weight |
1,6 kg |
|
Applicable Standards |
IEC 60044-7, IEC 60660 |
\